In this installation video, we show you how quickly and easily you can set up and install our insect screen roller blind for your door.
Suitable for the following Windhager products: 03218, 03894, 03895, 03909, 03980 (front installation)
Required tools: rolling metre, pencil, hacksaw, file, screwdriver, cutting bowl, cordless screwdriver.
Step by step to the perfect insect screen:
00:00 Unboxing
00:14 Measure the width dimension B of the reveal by finding the horizontal wall to wall distance.
00:18 Measure the height dimension H of the reveal by finding the vertical wall-to-wall distance.
00:24 Calculate the appropriate shortening dimension for your door.
00:29 Subtract 13 mm from the measured height.
00:42 Subtract 82 mm from the measured width.
01:00 Mark the measurement on the side to be shortened on the roller blind cassette.
01:08 Mark the calculated measurement on both guide rails.
01:19 Shorten the roller blind cassette and the handle rail at the marked point with a hacksaw.
01:30 Shorten both guide rails at the marked point with a hacksaw.
01:42 File off the interfaces on the blind cassette and the guide rails.
01:46 Remove the sealing brush on the cassette.
01:56 Pull out the sealing brush on the handle rail and guide it into the groove that is open at the bottom for later sealing to the door frame.
02:05 Put the shaft bearing onto the mandrel on the end cap.
02:10 Then place the connected unit on the roller blind cassette.
02:16 Screw it together with the two screws.
02:35 Insert the left handle lock into the handle rail on the side of the blind cassette.
02:46 Fix it by screwing in the grub screw with the hexagon socket.
02:53 Insert the right handle lock into the handle rail on the side of the blind cassette.
02:56 Fix it in place by screwing in the threaded pin with the hexagon socket.
03:00 Put the cover caps on the cassette.
03:09 Screw one screw each into the recesses provided in the lower clamping parts using a hexagon socket.
03:17 Insert the locking elements into the guide rails.
03:21 Insert the fastening elements into the guide rails.
03:30 Guide the blind to the door frame and mark the eight holes through the recesses on the fasteners.
03:40 Connect the guide rails to the roller blind cassette via the end caps.
03:56 Drill into the door frame with a ø 2.5 mm drill bit.
04:05 Screw the roller blind over the fasteners using screws.
04:09 Fit the screw covers to the blind.
04:27 To close the blind, pull the handle strip to the locking side.
04:30 This engages with the side latching elements. To open, push the handle bar outwards so that it unlocks.
![](https://s2.save4k.ru/pic/e-4-JhspIMI/maxresdefault.jpg)