Right to the point. No long winded talking. Reloading .410's on a MEC9000GN Progressive Reloader.
I forgot to mention station 1 is also the brass sizing, and station 2 also sets the primer.
Recipe: (I consistently get 1200 ft/sec from this load)
-- AA HS Hulls
-- Lil Gun Powder
-- MEC #10 or 11 Powder Bushing. (Weigh your own drops) #11 is better when using 410 tubes on and inertia trigger over and under. #11 is close to max. Weight it first!
-- CB5050-410HS. (Claybuster equivalent to WAA410HS)
-- Winchester .209 Primers
-- Eagle 1/2oz 9 Shot
My MEC #10 powder drop drops 13.1 grains of Lil Gun. Measure your own. I have two MEC #10 bushings. One drops quite a bit more than the other. Always verify the powder drop yourself.
If you're wondering about that hole in my bench, I put that there because I used to have a Ponsness Warren reloader that drops the finished shells all over your bench (Good loader, but really stupid design). When I set up the 9000, the hole was in the exact right place, so I went with it.
The black plate, that the reloader mounts to, is from MidwayUSA. My other 9000's will quick change into that. No more screwing the reloader down. I like it a lot.
