First video to the site! I've got a gimp thumb so can't ride...but been working on a few upgrades including the Thrashin' Risers. I've seen quite a few videos from folks where they show before/after but no one that's really going through the install and showing the various bits. Hopefully this is helpful. It's definitely a job anyone can do - just need the right tools...hell, I've only got one good hand and was able to do it myself.
If you want to get a bolt instead of reusing the factory stud when you do the risers - go to your local hardware store and find something to this spec:
1/2 - 13 x 3" (I've seen some suggest a 2 3/4" but 3 gives you a bit more room and the 2.75" are much harder to find) grade 8 flange bolts. The flange part just means the entire bolt isn't threaded...there's an area where it's not and that would be the part that will be closest to the head of the bolt and will be the part that's actually in the bushing.
Good luck and Ride Safe!!
