This is how to link and sync an Evinrude or Johnson outboard engine. We need to sync the carburetors, adjust the timing pointer, set the pickup timing, idle, and WOT timing. This is the BEST way to tune your boat's Evinrude/Johnson outboard engine. OUTBOARD TOOLS USED ↓↓↓↓

PLEASE DON'T SKIP STEPS!!!

Timestamps
0:00 Intro
0:55 Checklist
1:16 Sync Carbs
3:07 Timing Settings
4:30 Set Timing Pointer
7:24 Set Pickup Timing
8:24 Set Idle Speed
9:40 Set WOT Timing
13:11 Test Run On Water
13:28 Outro

Previous Videos:
➤ Evinrude Outboard Timer Base Replacement: [ Ссылка ]
➤ TDC Tool: [ Ссылка ]
➤ Throttle Amplifier Tool: [ Ссылка ]

Outboard Tuning Tools:
➤ Timing Light With Built In Tach: [ Ссылка ] (BEST FOR OUTBOARDS BUY IT!)
● Timing Light: [ Ссылка ] (Used In Video)
● Laser Tachometer: [ Ссылка ]
● Tachometer: [ Ссылка ]
● TDC Tool: [ Ссылка ]

Evinrude Outboard Ignition Parts:
● Stator: [ Ссылка ]
● Timer Base: [ Ссылка ]
● Power Pack: [ Ссылка ]
● Coil Pack: [ Ссылка ]
● Spark Plugs: [ Ссылка ]

This is a 1986 Evinrude 150 XP V6 Crossflow outboard.

As an Amazon Associate I earn from qualifying purchases.

Disclaimer: Matt's Shop is not responsible for any mechanical or bodily damages that result from performing these procedures. Moving engine parts can cause serious bodily injury. Be careful if you set the WOT full advance timing on your outboard engine. The flywheel spins at over 5000+ RPM. This can be very dangerous especially on a boat that goes 60+ MPH.

свернуть