In this video I go over how to install a teflon seal on a Ford high pressure power steering line. The process is simple enough when you have the correct tools. The tool I use in the video can be found in the kit linked below. The process involves simply placing the tool over the threads of the line and sliding the seal down the tool until it is in the seated position. This seal can also be installed without the use of special tools. In the video I give an example of a way to install the seal without a special tool. It involves using a punch to aid in stretching out the seal enough to get it over the threads of the line. The use of hot water may be helpful in the process. Soaking the seal for a few seconds may help it stretch and stay stretched a bit longer to aid in getting it over the threads in time. (Note: Do not over heat the seal as this can damage the seal. Be sure the seal contracts and fits snuggly on the line within a few minutes after installation. If it does not then a new seal will need to be installed. If you are not using the special tool then It would be recommended to purchase a few seals before doing the job as you are likely to damage one or two until you get lucky and get one to work. Use care not to get burned handling hot water. I'd only use hot water out of a household faucet. )
Note: The seal should slide down the tool or instrument you are using in order to spread it. Do not roll the seal. Also, if you are using a punch keep the seal on the round portion of the punch. Don't push the seal onto any part of the punch that may have sharp edges or pointed edges.
Note: Always insure that the seal is not leaking after the line has been installed on the vehicle. Usually, if a leak is present, it will show up after the system has been filled and the steering wheel has been turned back and forth with the engine running. Check for leaks after the engine has been shut down and the vehicle has been placed in park with the parking brake applied. If the seal is leaking a new seal will have to be installed.
Note: The seal shown in the video was installed using a 16mm tool. This tool is designed to install a 16mm seal. If you are installing a different sized seal then you will need a different tool. To my knowledge Ford uses a 16mm and a 14mm seal for applications such as the one shown in this video. Use the correct sized tool for the seal you are installing or damage may occur.
Here is a link to the tool mentioned in the video. It has a 16mm and 14mm seal installer:
[ Ссылка ]
DISCLAIMER
Barbour's Auto Help is not responsible for any damage or personal injury incurred in the process of performing any auto repairs done by you the viewer. Automotive repair is extremely dangerous. Repair your vehicle at your own risk. It is the viewers responsibility to verify all information and procedures as outlined in YOUR REPAIR MANUAL AND OWNERS MANUAL FOR YOUR VEHICLE. Owning and using a repair manual suited for your vehicle is essential for correctly and safely performing ANY repair to your vehicle. Always wear safety glasses and heed all instructions for use applicable to any piece of equipment you may use. Due to circumstances out of the control of Barbours Auto Help, Barbours Auto Help makes no guarantee that by the use of the information given in this video a quality repair will be made. Barbour'sAutoHelp makes no guarantee that the information provided is totally complete, syncronized and accurate. Verify everything using an appropriate repair manual.
Repair your vehicle at your own risk! Barbour's auto help does not guarantee a proper repair using these techniques.
