Morgue is a place where dead bodies are preserved with chemicals and kept in the refrigerated body store and examined in the post mortem room. Mortuary is the place where dead bodies are kept before burial/cremation. The concept of a modern mortuary, regards the mortuary as a culturally sensitive area in terms of public relation and helping to arrange for the disposal of those patients who die. Mortuaries occupy a special place in the perceptions of the community. Facilities and their staff involved in mortuary services have a clear obligation to look after the deceased in accordance with community expectations. Failure to do so is not only unacceptable but will raise valid community concerns about what takes place in mortuaries. Adherence to the Standards and Commentaries set out in this document will inspire confidence in this essential component of any health and justice systems. Many of the Standards and Commentaries relate to the design, construction and provision of services, e.g. water supply, storage and electricity, and it is strongly advised that they are implemented where new mortuaries are being designed as they represent world best practice.
This is USER GUIDE made for general public information to make use of mortuary freezer easy and safe.
1. PREPARATION BEFORE STARTUP
• The unit should be located so that air may circulate freely and not be recirculated from the condensing unit. for proper air flow and access all sides of the unit should be a minimum of 8” away from any wall or obstruction
• Remove all covers attached to the compressor unit before starting Operation.
• Plug in power cord to your 16 Amp 3 Pin Power supply plug (Supply voltage - 230V +10% 50 Hz)
(CAUTION – Earth connection is essential for safety purpose)
• Cabinet body is equipped with a drain connection on right end. Provide easy passage below the connection for cleaner operation.
2. STARTING COMPRESSOR OPERATION
• Switch on Power supply.
• Compressor will start its operation and Ice will form on the interior cabinet walls.
(NOTE: Temperature controlling is fully automatic so there is no need to make any change in the temperature controller it may damage the whole electrical connection. It may result in machine failure.)
3. LOADING AND UNLOADING
• To load the morgue in the cabinet. First take out power plug from the electric panel.
• Than unlock the door from the right by rotating it clockwise.
• Now lift up the door by handle and slightly slide right and take down door.
• Take morgue tray out from the cabinet.
• Follow the same procedure to load the morgue tray and close door.
(NOTE : Do not keep door open for efficient working)
4. CLEANING
• Wash the equipment (Inside and outside cabinet walls) with soap (e.g. Liquid dish soap) and clean water.
• Rinse the equipment completely with clean water.
• Disinfect the equipment to inactivate any remaining pathogens.
5. PREVENTIVE MAINTENANCE OF EQUIPMENT
• Check condition of condenser. Look for accumulation of dirt and debris (clean as required).
• Check for unusual noise or vibration. Take corrective action as required.
• Inspect wiring for signs of wear or discoloration and repair if needed.
For any query or product information visit us at www.widecool.in or contact us @ +919033088851 or write us at – info@widecool.in / himalay.ref@gmail.com
Wide cool / Himalaya refrigeration proudly manufactures Mortuary machine in India with a high quality and superior features.
Proudly 100 % manufactured in INDIA
Ещё видео!