Click for more info and reviews of this CURT Hitch Adapters:
[ Ссылка ]
Check out some similar Hitch Adapters options:
[ Ссылка ]
[ Ссылка ]
Don’t forget to subscribe!
[ Ссылка ]
Full transcript: [ Ссылка ]
Brad Hello, neighbors, it's Brad here at etrailer and today we're taking a look at the Curt Reducer Sleeve that's gonna take our receiver tube opening from a two and a half in to a two inch. So, if you have that two inch ball mount and you've upgraded to a heavier dutier truck and or maybe you just have a couple trucks in your fleet no worries. You're not going go have to buy a whole separate ball mount. You can go ahead, put that sleeve in place and be able to put your two inch ball, no problem. I really like that I can from my pickup with a two inch receiver to my diesel with a two and a half inch without having to get any additional equipment. Now it also has two notches on here which makes it nice and easy.
That way when you slide this in you can't push it too far. It's not gonna get stuck in there, you're always gonna have a little edge here to be able to pull that out if you do need to go back to that two and a half. Now what's also nice is you're not gonna need a special pin and clip. You'll just be able to slide this through. You'll align your holes and then your normal pin and clip will go through, holding that all in place.
Now you can see that our ball mount has seen better days as it's starting to rust but the great part about this being steel construction with that black powder coat finish, that's gonna hold up against that rust and corrosion so you're not gonna see that transferring over for a long time. And that was a look at the Curt Reducer Sleeve, going from a two and a half inch to a two inch..
