Watch for my "quick change" wardrobe magic. It's all done. Here it is - the Fokker DR1 balsa model kit. Some final tips and tricks!
0:00 Intro
0:20 Some pictures
1:50 Electronics and wires
4:10 Landing gear
5:20 The hatch (again)
6:10 Cowling installation
9:00 Propeller
7:50 No pan/tilt! FPV
12:50 Left over bits!
18:05 She's done!
18:40 Ailerons!
19:20 Like and Subscribe
Here's some links to some of the components. Some are affiliate links.
Buy the Dancing Wings Hobby Fokker DR1 Kit from AliExpress (affiliate):
[ Ссылка ]
Be sure to choose the "color" - there are many options from the basic kit to a full PNP pack including motor, ESC, servos, covering, DEVO transmitter and receiver. I bought S1702 which includes the correct MM2212 motor which is important because of the way it needs to be mounted.
You can also buy direct from Dancing Wings on their website. I found the customer service excellent:
[ Ссылка ]
The SN-L+ LeFei RC flight controller I'm going to use (affiliate):
[ Ссылка ]
The FS-X6B receiver I'm using - no soldering required!:
[ Ссылка ]
These ZOP 1500 mAh batteries fit perfectly for:
[ Ссылка ]
The switch needs to be rated for the 20A that this model will peak at. I went for this 30A switch to be safe. (an it's red so it looks great on this model). (Affiliate)
[ Ссылка ]
The 2.2g digital servos used for the ailerons:
[ Ссылка ]
The SG50 5g digital servos I used for the elevator/rudder (affiliate):
[ Ссылка ]
THE AKK Transmitter/Camera combo I used for the FPV setup (this is from Amazon Canada. Not sure where you can by this elsewhere):
[ Ссылка ]
![](https://i.ytimg.com/vi/j0-nOXJR5h4/maxresdefault.jpg)