I make a Twisted Steel Rebar Industrial Style Handle. I love the look of industrial furniture and all the decor that comes with it, and this handle has the look I like. I hope you enjoy my video of the metal twist handle, it was a lot of fun to make a nice MIG welding project.
The wide flat bar is 6mm thick, 50mm wide, and 225 long. The small flat bar is 6mm thick 32mm wide and 57mm long. The rebar is 7mm rebar. The distance between the two uprights is 145mm.
The main tools used, are a MIG welder, angle grinder, drill, and bench vise.
Tools / Supplies, I often use are.
Marking out Tools
Markal Silver-Streak Metal Marker Round: [ Ссылка ]
Milwaukee 4pk Inkzall Black Ultra Fine Point Pens: [ Ссылка ]
Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker 12 Pack: [ Ссылка ]
Locking Pliers – Vise Grips
MILWAUKEE 10” Locking Pliers, Curved Jaw: [ Ссылка ]
Milwaukee 6" Long Nose Locking Pliers: [ Ссылка ]
Milwaukee 6” Locking Clamp Regular Jaws: [ Ссылка ]
KNIPEX Tools Long Nose Grip Pliers: [ Ссылка ]
Magnets
Magnetic V-Pads Kit, Magnets On Both Pad Face & Bottom: [ Ссылка ]
Mini Magnetic Fabrication Square Magnets Angles: 30°, 60°, 45°, 90°: [ Ссылка ]
“L” shape Corner Square Magnets 12°, 90° & 60° Angle Setting: [ Ссылка ]
My camera set-up.
Canon EOS M6 Mark II Camera 15-45mm Lens: [ Ссылка ]
VideoMicro Rode Compact On-Camera Microphone: [ Ссылка ]
Camera Tripod Vanguard Alta Pro 2: [ Ссылка ]
The Brand of the Drill bits, and cutting/flap discs, is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: [ Ссылка ]
As an Amazon Associate, I earn from qualifying purchases. This means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support!
►►Subscribe to our Channel for more videos ►► [ Ссылка ]
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load. I love the look of industrial furniture and all the decor that comes with it, and this shelf bracket has the look I like. A nice MIG Welding Project using rebar
