Windshield Wiper and Washer Controls
This lever is used to control all windshield wiper and washer functions. To operate your windshield wipers and washers, your ignition must be ON.
For INTERMITTENT wiper control, push the lever down to the first stop. The time delay of the wiper sweep is adjusted by turning this ring. The narrow markings indicate a short delay. The delay gets longer as you turn the ring toward the wider markings. The wipers will operate on continuous low-speed by pushing the lever down to LO, the second stop. Push down again to HI, the third stop, for continuous high-speed operation. In conditions of mist or light rain, push the lever up to MIST and you will get a one sweep operation of the wipers. To clean the windshield, pull the lever toward you. Washer fluid will spray and the wipers will automatically sweep several times and stop.
To operate your rear windshield wiper at a preset intermittent speed, turn the knob on the end of the lever to INTERMITTENT. For continuous low-speed operation, turn this knob to ON. To turn the rear windshield wiper OFF, turn the knob to this position. To clean the rear window, push this lever forward. Washer fluid will spray and the wiper will automatically sweep several times and stop.
To move the wiper arm to a position that allows for easy wiper replacement or cleaning of the lower windshield, turn the ignition and intermittent wiper system off. Then within one minute pull the wiper control lever toward you. The wiper arm should extend and stop in mid-sweep. The wiper arm can then be pulled away from the windshield for replacement or cleaning.
