Coding Remote Control Hand Transmitters
The three (3) transmitters supplied with your opener are preprogrammed at the factory.
Note: A maximum of six (6) codes can be learned by the opener. If you attempt to code more than six (6) transmitters the first code will be deleted.
1. Additional transmitters can be coded as follows:
❖ Press and hold the “P” and “+” buttons until all lights turn on and LED 7 flashes
❖ Press the “+” button once (all LED lights turn off except LED 7)
❖ Quickly press and release the required push button on your remote twice (all LED lights turn on and LED 7
will begin flashing)
❖ Press the “P” button once to save (LED 3 will switch on indicating that the remote has been successfully
programmed)
Repeat above procedure for all additional handsets.
2. Deleting transmitters:
Note: This procedure will clear all programmed remotes, wireless wall buttons and wireless keypads from the opener.
❖ Press and hold the “P” and “+” buttons until all lights turn on and LED 7 flashes
❖ Press and hold the “-“ button until LED 7 turns off and begins flashing again
❖ Press the “P” button once to save (LED 3 will switch on indicating that all codes have been deleted and that
the opener is now in normal operating mode)
Follow procedure 1. above to code new remote control hand transmitters.


Auto-Close Timer
Safety Beams must be installed to activate this feature.
When the Auto-Close Timer is enabled the door will close automatically after a preset period of time (2.5 minutes). During the door open waiting period the LED courtesy lights will remain on. If an obstruction is detected during closing, the door will fully open and the Auto-Close Timer will begin again.

To Activate:
1) Press and hold the “P” button for 6 seconds (all LED lights turn on and LED 2 flashes)
2) Press the “P” button once (LED 4 starts flashing)
3) Press the “P” button once (LED 6 starts flashing)
4) Press the “P” button once (LED 1 starts flashing)
5) Press the “P” button once (LED 8 starts flashing)
6) Press the “+” button once (all LED lights turn off except LED 8)
7) Press the “P” button once to save (LED 3 turns on)
The unit is now in normal operating mode with the Auto-close function enabled.


To Deactivate:
1) Press and hold the “P” button for 6 seconds (all LED lights turn on and LED 2 flashes)
2) Press the “P” button once (LED 4 starts flashing)
3) Press the “P” button once (LED 6 starts flashing)
4) Press the “P” button once (LED 1 starts flashing)
5) Press the “P” button once (LED 8 starts flashing)
6) Press the “-” button once (all LED lights turn off except LED 8)
7) Press the “P” button once to save (LED 3 turns on)
The unit is now in normal operating mode with the Auto-close function disabled.

That Roller Door Bloke - Your Repair & Automation Specialist
Roller Door Repairs Adelaide
Garage Door Repair Near Me, Emergency Garage Door Repair Near Me, Garage Motor Repairs Near Me, Same Day Garage Door Repairs, Residential Garage Door Service, Garage Door Companies,
Garage Door Opener Installation, Garage Door Service, Garage Door Spring Replacement, Garage Door Maintenance, Quick Garage Door Service,

свернуть