This video details the install or retrofit of a Voron 2.4 core-xy printer to canbus via the BigTreeTech EBB36 and the Waveshare RS485 Canbus Hat ( can bus ) for the Raspberry Pi 4. It covers installing Klipper onto the EBB36 card, mounting, cables, umbilical and reconfiguration of the printer.cfg files. This should mostly apply to the EBB42 and some is applicable to the fly sht 36, fly sht 42, Huvud, turbocan and canable can bus controllers.
Special note:
When making the video, I failed to record terminating the EBB36. For reliable communications on the canbus, please make sure you terminate the EBB36 with the jumper.
A Raspberry PI 4 or CM 4 are highly recommended. People have reported communication issues with the Raspberry PI 3. Devices more powerful than a Raspberry PI 4 are probably fine as well.
Resources used (I receive commissions that directly contribute to content creation on this site):
The EBB36 & U2C: [ Ссылка ]=
EBB36: [ Ссылка ]
U2C: [ Ссылка ]
CanHat: [ Ссылка ]
Green filament: The filament: [ Ссылка ]
or
The military green ABS and black ASA filament: [ Ссылка ]
Maz0r's github page on how to configure canbus: [ Ссылка ]
BigTreeTech github instructions: [ Ссылка ]
Useful wiring guide: [ Ссылка ]
Voron Startup instructions and checks: [ Ссылка ]
Rear Umbilical mount (the one used in the video): [ Ссылка ]
Rear Umbilical mount (the version I modified for more clearance): [ Ссылка ]
Front EBB36 mount: [ Ссылка ]
I used this for the z-chain relocation: [ Ссылка ]
Instagram: [ Ссылка ]
My printer.cfg file: [ Ссылка ]
Carriage mount with x-endstop mount: [ Ссылка ]
Discord Can-Bus stop: [ Ссылка ]
Fluidscape by Kevin MacLeod is licensed under a Creative Commons Attribution 4.0 license. [ Ссылка ]
Source: [ Ссылка ]
Artist: [ Ссылка ]
