Click for more info and reviews of this Wheel Masters Tire Repair Tools:
[ Ссылка ]
Check out some similar Tire Repair Tools options:
[ Ссылка ]
[ Ссылка ]
Don’t forget to subscribe!
[ Ссылка ]
Full transcript: [ Ссылка ]
Hello, everybody, this is Jeff at etrailer.com. Today I'm gonna take a look at the Wheel Masters Tire Pressure Valve Extenders with the 180 degree bend for your rear wheels. This is for a quantity of two extenders. Now these are angled valve extenders. They make it very easy to access the valve stems on your rear tires with the dual wheels. These are sturdy nickel-plated brass stems.
You can see they're bent at a 180 degree angle and they'll screw onto your existing valve stem. Basically that 180 degree bend will place the valve stem in a lot easier to reach spot. Basically, if you notice on those dual wheels usually that inner wheel will have the valve stem pointing towards the center of the vehicle or the trailer. And it's hard to access that valve stem. So when you install these, it'll bring it out to where you could easily access it.
These are a corrosion-resistant, nickel-plated brass construction, makes it long lasting. These will work on both steel and aluminum wheels. And to install it, it's pretty easy. All you have to do is take off the valve cap on your valve stem that's on your wheel. Take this end here, put it on there, twist this, tighten it down, snug it up, so it doesn't leak.
And then right here, you'll have your end cap here that'll replace your existing valve stem cover. So you just remove that and that'll give you easy access to putting air in or checking the air pressure. These parts are made in the USA. Now there are also extenders that are available that offer other angles, like 45 degrees, 90 degrees, and 135 degrees. Those items we do sell separate on our website.
These again are 180 degree bend. But that should do it for the review on the Wheel Masters Tire Pressure Valve Extenders with the 180 degree bend for rear wheels..
Ещё видео!