Buy Now!
New Control Arm with Ball Joint Set from 1AAuto.com [ Ссылка ]

Control arms are a crucial part of the suspension system of your vehicle. They not only carry the load of the vehicle to the wheel, but they typically also maintain its alignment. Control arms are typically large and strong, so you may be surprised it needs replacing. They contain rubber bushings for smoother rides at the cost of eventual wear. This video shows you how to install a new quality TRQ lower control arm in your 2013-17 Nissan Sentra.

• Buy TRQ at 1AAuto.com: [ Ссылка ]
• Check here for more videos on the 2013-2019 Nissan Sentra: [ Ссылка ]

This process should be similar on the following vehicles:
2013 Nissan Sentra
2014 Nissan Sentra
2015 Nissan Sentra
2016 Nissan Sentra
2017 Nissan Sentra
2018 Nissan Sentra
2019 Nissan Sentra

Tools you will need:
• Pry Bar [ Ссылка ]
• 14mm Wrench [ Ссылка ]
• 18mm Wrench
• 14mm Socket [ Ссылка ]
• 18mm Socket [ Ссылка ]
• 21mm Socket [ Ссылка ]
• 22mm Socket [ Ссылка ]
• Pickle Fork
• 1/2 Inch Air Impact Gun [ Ссылка ]
• Swivel
• Torque Wrench [ Ссылка ]
• Rust Penetrant
• Center Punch [ Ссылка ]
• Hammer [ Ссылка ]
• Rubber Mallet [ Ссылка ]
• Sledge Hammer [ Ссылка ]

Subscribe: [ Ссылка ]

Check out our playlist:
Nissan Sentra 2013-19 7th Generation: [ Ссылка ]

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

свернуть