To retrofit a Fusion AP to Fusion PC gun, you simply replace the fluid section. To do this:
1. Remove the nut and grab the fluid housing.
2. Take your fluid housing and screw it onto the handle.
3. Take the mix chamber, with the alignment groove in the down position and insert that into the fluid housing.
4. Grab the ProConnect cartridge and make sure the purge air port is in the up position and put that in the mix chamber.
5. Take the retaining ring and spin that on. Then put on the air cap.
Now your Fusion AP is fully converting into a Fusion PC gun.

To learn more, visit [ Ссылка ]

свернуть