In this film I give an overview of the modifications I've made to improve the performance of the cross slide on my 7x14 Chinese mini lathe. I replace the hard to use graduated dial, add bearings, increase the cross slide travel and make a replacement gib strip.

Details for the homemade aluminium anodising setup mentioned in the video: [ Ссылка ]

Details for the homemade tailstock die holder mentioned in the video: [ Ссылка ]

Details for the homemade rotary broach mentioned in the video: [ Ссылка ]

Approximate imperial sizes are shown. They're not direct equivalents, but are intended to give the non-metric viewer a rough feel for what I'm doing.

Made with subtitles -click the CC box.

-------------

For the material I couldn't capture myself, my thanks goes to the following:


Whoosh by Aysonny [ Ссылка ] Licensed under a Creative Commons Attribution 3.0 Unported License ( [ Ссылка ] )

-------------






Shot: HDC-HS700 1920x1080 50P AVCHD
Edit: FCP7 ProRes 422
Mic: DR-05

свернуть