This video is an addendum to the original tutorial ([ Ссылка ]) and shows how to install/upgrade feeder software running Python 3 . It is meant to replace the Section 1 Step 4 ("Configure Feeder Software") which in the original video starts at 14 minutes 34 seconds and ends at 23 minutes 01 second. Once you finished this video you can continue on with the rest of the original tutorial at 23 minute mark as the rest of the tutorial is the same from there on out. The written instructions have already been updated with Python 3 instructions and can be found here [ Ссылка ]
This video is necessary because in the the original tutorial the feeder software was written in python 2. Since then python 3 has been released and it has been announced that python 2 will no longer be supported as of January 1, 2020. If your feeder is still running the original version of the software that is not to say your feeder ill just stop working on January 1, 2020 but rather the software will just not be officially supported by Python and will stop receiving bug updates and patches. I have personally been running my feeder running python 2 for several years now without having to upgrade, that being said it is still best practice to go ahead with the software that be supported moving forward and that is python 3. If you have any questions about upgrading from Python 2 or just any questions in general please reach out to me in the comments below
Original tutorial video:
[ Ссылка ]
Full written instructions:
[ Ссылка ]
![](https://i.ytimg.com/vi/lQvNneiMdXU/maxresdefault.jpg)