Part 2: Installing the logo light as DRL using the Xenon wires:
[ Ссылка ]
The item I have bought from the eBay seller has sold out so, here is the results eBay page or just search on eBay "front Audi glowing light logo."
[ Ссылка ]
1. Just carefully pry (like a flathead screw driver) out the logo on one side.
2. Then grab another flat prying tool (make sure to not scratch the original logo.
3. Then carefully pop out the multiple hinge's/ clips it has.
4. Buy the Home Depot Silicone product, & extend it inside of the LED's compartment on the back side of the logo that kisses the grill.
5. Install the double sided special sticky tape onto the grill if the product you bought comes with one.
6. Stick the wire though the grapple hinge connector, & shift the wire to the tiny gap on the left or right
7. Place & press the emblem against the grill & it should look evenly aligned.
8. To fully waterproof it, use the CLEAR silicone to protect the LED's from any exterior gaps that may leak water in, by using a finger-sized tool to add the silicone in the gap.
9. Wipe the undried excess carefully without leaving any smudges & without removing too much of the silicone, with microfiber towel.
10.Wait till it dries, then proceed to peel off the dried silicone, it an easy yet tedious clean-up.

I am still waiting for my rear one to arrive; wondering how to get that one installed without the wire showing and or popping the emblem out of place... smh.
Forgot to mention, the quality looks the same but the "glowing" one is made out of material that causes light to see through. I made a small scratch on the inside of my original to see if I can just reuse my original, but I can't the MATERIAL, NOT COLOR is not see through in the original.

Show support by subscribing & turn on bell notifications to see my weekly uploads! :)

Want to know where I buy my products? Click links below to see my list & get discounts!
[ Ссылка ]

ECS Tuning Free Shipping on Orders $49 & Up!
[ Ссылка ]
-----------------------------------------------------------------------------------------------------------

Support me | [ Ссылка ]
Snapchat: [ Ссылка ]
Instagram: [ Ссылка ]
Email: yb.motorheadtech@gmail.com

-----------------------------------------------------------------------------------------------------------
Check out my newest diagnostic tool!
[ Ссылка ]
-----------------------------------------------------------------------------------------------------------
This video is presented to you by ECS Tuning:

Shop Audi & VW Parts & performance
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]

Need BMW parts & performance by ECS Tuning?
[ Ссылка ]
[ Ссылка ]
[ Ссылка ]

Need more ECS German Parts? Click here
[ Ссылка ]
-----------------------------------------------------------------------------------------------------------
-----------------------------------------------------------------------------------------------------------
#motorheadtech #audi #porsche
Thank you for watching Part 1: Audi Grill Logo Lights up from Front, Rear light is TBA!
Thanks for your supporting my Audi A4 build, keep sharing, liking & subscribing to this DIY Mods & Vlogs channel!! :)

DISCLOSURE: This channel may earn a commission when using the coupons/links to make a purchase.

свернуть