Here’s how i tuned my Elegoo neptune 4 and 4 pro machines. I hope this helps get you started on your klipper journey, if you have any questions or tips i dont mention here feel free to leave a comment below. Check out todays video sponsor @ElegooOfficial here: [ Ссылка ] (affiliate link)
COMMANDS:
Run the mesh bed leveling - BED_MESH_CALIBRATE
Enable temperature tower - TUNING_TOWER COMMAND='SET_HEATER_TEMPERATURE HEATER=extruder' PARAMETER=TARGET START=200 STEP_DELTA=5 STEP_HEIGHT=5
Run PID tuning
Hotend - PID_CALIBRATE HEATER=extruder TARGET=230
Bed - PID_CALIBRATE HEATER=heater_bed TARGET=65
PID value should be formatted this way under the extruder and heater_bed sections:
control :pid
pid_kp : xx.xx
pid_ki : xx.xx
pid_kd : xx.xx
Pressure advance
Run this command first - SET_VELOCITY_LIMIT SQUARE_CORNER_VELOCITY=1 ACCEL=500
Then this command - TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.005
Pressure advance model can be found here: [ Ссылка ]
#elegoo #neptune4pro #3dprinting
