Active BMS [ Ссылка ]
AMAZON [ Ссылка ]
🔋Battery Pack DIY Holder, Nickel Sheet Parts [ Ссылка ]
⚡4 MASTER BOOKS AMAZON ⚡
[ Ссылка ]
0:00 Introduction to JK BMS
2:43 BMS Setting guide
3:36 Step 1: Use pre-entered settings.
3:21 Step 2. Basic Settings
4:18 Step 3. Advance Settings
12:21 Step 4: Go to the Control tab.
15:03 Final Step Status Setting Status
16:50 Precautions
Li-ion battery specifications
Full Charge Voltage 4.2V
Cut Discharge Voltage 2.5V
Li-ion BMS standard settings chart
Over Charge Detect Voltage 4.25v
Over Charge Release Voltage 4.13v
Balance Detect Voltage 4.13v
Over Discharge Detect 2.7v
Over Discharge Release Voltage 3.0v
LiFePo4 battery specifications
Full Charge Voltage 3.65V
Cut Discharge Voltage 1.8V
LiFePo4 BMS standard settings chart
Over Charge Detect Voltage 3.75v
Over Charge Release Voltage 3.55v
Balance Detect Voltage 3.5v
Over Discharge Detect 2.2v
Over Discharge Release Voltage 2.3v
BMS setting guide
The initial password required to change settings is 1 2 3 4 5 6.
Step 1: Use pre-entered settings.
Li-Ion:
LIFEPO4
LTO
Lithium titanate (Li4Ti5O12)
Step 2. Basic Settings
Cell Count
Battery Capacity Ampere Hour
Balance Trigger Volt
Calibrating Volts
Calibrating Current Ampere
Step 3. Advance Settings
Start Balance Volt
Max Balance Current Ampere
Cell OVP Volt
SOC-100% Volt
Cell OVPR
Cell UVPR Volt
SOC 0% Volt
Cell UVP Volt
Power Off Volt
Continued Charge Current Ampere
Charge OCP Delay Second
Charge OCPR Time Second
Continued Discharge Current Ampere
Discharge OCPR Time Second
Charge OPT Celsius
Charge Over-Temperature Protection
Charge OPT Celsius
Discharge OTP Celsius
Discharge OTPR Celsius
Charge UTP Celsius
Charge UTPR Celsius
MOSFET OTP Celsius
MOSFET OTPR Celsius
SCP Delay Microsecond
SCPR Time Second
Device Address
Step 4: Move to the Control tab.
ModifyPWE
Charge
Discharge
Balance
Emergency
Disable Temp Sensor
Port Switch
Smart Sleep on
Final Step
Go to the Status tab.
Charge
Discharge
Balance
Battery Power
Battery Capacity
Remain Capacity
Remain Battery
Cycle Count
Cycle Count Ampere hour
Time Emergency
Average Cell Voltage
Cell Voltage Difference
Balance Current
MOSFET Temperature
Battery T1:
Battery T2
Cells Wire Resistance
