I started with a 6 3/4x13-in scrap piece of birch plywood then I laid out for my oops clamps and my carbide 3D clamps and then I laid out 50 holes for some bolts and then used a 1/8 " down cut bit using carbide creates cut settings for an 8 in bed so it took an hour and 25 minutes to do the full pocketing and cut out I forgot to check to make sure my bit would reach the waste board so it stopped with about 3 mm left so then cut it out on the bandsaw and give it a quick sand hope you enjoy the video
#ONEFINITY
#cncbits.ca
#OOPSclamps
Ещё видео!