SP108E Wi-fi LED controller. [ Ссылка ]
Long distance APP remote control via WI-FI;
Support routing mode(AP) and connection mode(STA);
Support almost every kind of one-wire or two-wire LED driver IC ;
Brightness adjustable, With 180 kinds of patterns and 8 kind of color adjustable patterns;
Creatively using from-image-to-effect method for user to DIY any effect;
Support setting pixel number and segments number, able to control up to 2048pixels;
WS2811 WS2812B WS2813 SK9822 APA102 LED Strip Light Tape and many another.
AP(Access Point) mode: Controller and Phone connect directly, controller works as an access point.
Connect steps:
1) When the device is not connected to any WI-FI network, power on the controller and wait for 20s and then controller will switch into AP mode ;
2) In the WI-FI setting page,find and connect the controller (named like SP108E_xxx, the default pin code is 12345678),
3)Open the LED Shop App ,then the controller will be showed on the device list;
*STA(Station) mode: Controller and phone are in one same WI-FI network, in this network, users can operate the controller smoothly.
Connect steps:
1)When the device is not connected to any WI-FI network,power on the controller,controller will be remain in Wait-For-Connet mode for 20 seconds;
2) Make sure that your phone is connected to a WI-FI network, Open LED Shop APP, pressing the Add Device button,input the WI-FI pin code, then press the OK to confirm and wait for the configure processing finish;
3) When controller successfully enter the WI-FI network, it will be showed on the device list;
4) User can select the controller and remove it out of the network by pressing the Remove Device button,then the controller will switch into AP mode.
Ещё видео!