This week, we're going to be looking at replacing the water flow switch on a 50-watt laser engraver I recently purchased, with a water flow sensor I purchased on Amazon. If the water flow switch on your co2 laser engraving machine fails, it will prevent your laser cutter from firing. This laser cutting machine is similar to the popular k40 laser cutter and other Chinese laser engravers, so the setup process should be similar on most of them.
******Check out other videos in this series******
Chinese CO2 Laser Engraver / 50w Laser Cutter Guide Ep. 1: [ Ссылка ]
CO2 Laser Engraver Air Assist & Exhaust. Beginner Series Ep. 2 : [ Ссылка ]
CO2 Laser Engraver Water Cooling & Laser Chillers. Beginner Series Ep. 3: [ Ссылка ]
CO2 Laser Software / K40 Whisperer & Inkscape / Beginner Series Ep. 4: [ Ссылка ]
CO2 Laser Alignment and How to Clean Laser Lens and Mirrors / Beginner Series Ep. 5: [ Ссылка ]
CO2 Laser Focus / Focusing Laser Lens Ramp Test - Laser Engraver Beginner Series Ep. 6: [ Ссылка ]
*********************
#WaterFlowSwitch #CO2LaserCutter #WaterSwitch
Get the Water Flow Switch: [ Ссылка ]
* Official Website [ Ссылка ]
* Follow on Instagram - [ Ссылка ]
