1. Recheck the Connection and find out x axis driver is connected wrong
2. Adjust the D.C. Power supply to output D.C. 24v. It used to be 20v. The power supply provide power to x, y axis driver and the dsp controller.
3. Replace X axis belt because it got a cut on the edge.
4. Replace two limit switches. Drill holes to install the limit switches
5. Remove unnecessary part that left in the xy stage.
6. Soldering the end bare wire for better connection
7. Oh Use shrink wrap to cover the bare wires as needed.
![](https://s2.save4k.ru/pic/o3VqTum8XR0/maxresdefault.jpg)