How to extract the Diamond Drum from the SMITH FS351 self-propelled Shaver, Planer, Scarifier.
These 8 steps can be used for removing any SMITH scarifier, planer or shaver drum assembly.
1. Lower the equipment onto a flat working surface using the lifting points and safety strap.
2. Lower the drum to the lowest setting to engage the rear swivel wheels with the drive wheels off the surface.
3. Remove the side plate bolts and the diamond drum arbor locking set-screw.
4. Pull out the drum assembly.
5. Check condition of the drive bearings, drive shaft and inner housing for concrete or material buildup.
6. Replace any worn components and clean inner housing without water.
7. When replacing the drum assembly, add anti-sieze lubricant to the drive shaft.
8. It is a best practice, to daily inspect the drum assembly after use and prior to the next job.
Always maintain ample supply or consumables and replace components as necessary.
Any questions, please contact your SMITH Representative.
SMITH Manufacturing
954-941-9744
www.removefaster.com
1610 S Dixie Highway
Pompano Beach, FL 33060 USA
Ещё видео!