I’ve wanted to make an electric SSQA remote control for the LA525 loader on my Kubota L3901 for a while now and finally got around to tackling it. The ideas and techniques I use should be able to be adapted and applied to a wide range of loaders. This is Part 1. NOTE: I strongly recommend watching Part 2 before buying any hardware and starting your build.
Materials:
* ECO LLC 8 Inch 8" 225lbs 0.55in/sec 12VDC Linear Actuator: [ Ссылка ]
* 15 Ft 6AN ID Braided Stainless Steel Fuel Line Hose: [ Ссылка ]
* Waterproof Latching Polarity Reversing Rocker Switch: [ Ссылка ]
* GS Power 16 Gauge Wire 100 Ft Two Conductor Copper Wire: [ Ссылка ]
* 2-Pin Waterproof Electrical Connectors, 10 Pack: [ Ссылка ]
* Alex Tech 25ft – 1/4 inch Split Wire Loom: [ Ссылка ]
* Alex Tech 25ft – 1/2 inch Split Wire Loom: [ Ссылка ]
Recommended Special Tools:
* Crimping Tool for Waterproof Connectors: [ Ссылка ]
* Starrett 18A Automatic Center Punch: [ Ссылка ]
Note: Links to Amazon products are Amazon Affiliate links that won’t cost you any extra, but will help support my efforts with a small commission on qualified products. Thanks for your support!
Chapters:
00:00 Introduction
01:26 Demonstration
02:46 Design Measurements
04:32 Choosing a Linear Actuator
05:48 Testing the Actuator
07:58 Building the Parts
Visit my Amazon Affiliate Store: [ Ссылка ]
Visit DIYMyWay.net: [ Ссылка ]
Follow Me on Twitter: [ Ссылка ]
#diy #outdoors #tractors #rurallife #kubota
Ещё видео!