🙌Guys, if your Comgo Z1 can't connect with Lightburn or LaserGRBL, plz have a look at this video💕

Tutorial introduction:

0:05 Solution 1: Check the USB cable
(Tips: Check whether the cable is faulty. If so, change a good quality one and see if it works)

0:37 Solution 2: Check the driver “CH340SER”
(Tips: The driver file “CH340SER” is loaded in the SD card that comes with your Comgo Z1 machine)

2:17 Solution 3: Check the firmware version and change the correspondent baud rate (Tips: The firmware V2.0 corresponds with the baud rate of 11520; while the firmware V2.1 with 921600)
Download link of the firmware V2.1👉 [ Ссылка ]
2:20 Refresh the firmware to V2.0
4:03 Refresh the firmware to V2.1
5:28 After refreshing the firmware, connect with Lasergrbl

🚨Reminder
If you have tried all the steps before, but the problem still occurs, plz provide a detailed video to our support email (for us to decide whether the replacement should be reissued)

💌Comgrow support email:
Official store support👉👉👉 service@comgrow.com
Amazon support 👉👉👉 laserengravingcnc@comgrow.com

💗Comgrow official store: [ Ссылка ]

💟Social media:
Facebook official page: [ Ссылка ]
Facebook Comgo Z1 user group: [ Ссылка ]
Instagram: [ Ссылка ]
Twitter: [ Ссылка ]
Reddit: [ Ссылка ]
Facebook CNC user group: [ Ссылка ]

#comgrow #laser #lasercutting #laserengraving #laserengravingmachine #lasercuttingmachine #tutorial #troubleshooting #firmwareupdate

свернуть