Pre-order VLMP Here: [ Ссылка ]
Check out PCBway: [ Ссылка ]
The Mellow Fly-Pi by 3D Mellow and Team Gloomy is a raspberry pi alternative that comes in at a very reasonable cost. This could be just what many of you area looking for to get your 3D printers network attached with klipper so I've made a guide to help you over that initial hurdle of getting setup.

-------Purchase Link--------
Get Mellow Fly pi here: [ Ссылка ]
Note: Affiliate links tell the shop that I sent you. If you purchase, it costs you nothing extra, but I get a small cut from the seller which helps support the channel and allows me to take time to make great videos for you to watch.

--------Useful Links----------
Balena Etcher: [ Ссылка ]
PuTTY: [ Ссылка ]
FlyOS Image: [ Ссылка ]
Notepad++: [ Ссылка ]

----Continue as normal links----
1) mellow board: [ Ссылка ]
2) Board specifc guides. no link.
3) General Klipper Guide: [ Ссылка ]

Patreon: [ Ссылка ]
Twitter: @Adam_V3D
Join the Vector 3D Discord: [ Ссылка ]
Vector 3D Shop: [ Ссылка ]

Tools:
Wera Hex Keys: [ Ссылка ]
Wera Ratchet and Socket Set: [ Ссылка ]
Knipex Cutter: [ Ссылка ]
Ifixit Tool kit: [ Ссылка ]
Wire Stripper Tool: [ Ссылка ]
3M Applicator Tool: [ Ссылка ]

0:00 Raspberry Pi Alternative
0:36 Introduction to Mellow Fly-Pi
1:14 Sponsor Segment
1:45 What's included in the box
2:50 Preparation
3:51 How to Flash FlyOS Klipper Firmware
4:32 How to Configure FlyOS
7:00 How to Mount Mellow Fly-Pi
7:40 How to Wire up Mellow Fly-Pi
9:19 First Boot
10:30 Continue with normal Klipper Configuration

свернуть