Check out the review of Stefan Burger's 4 to 8-way motorized restrictor gate changer and the GRS USB Button Hole Spinner and see how I modded an AtGames Legends Ultimate, Legends Gamer Pro, and an Arcade1Up.
***UPDATE 1/16/24: GRS will soon be offering a new swappable board for the GRS V2 Buttonhole Spinner and GRS V2 Buttonhole Push Pull Spinner. You can see the test and how it makes a difference at the link below (12:10 minute mark for AtGames):
[ Ссылка ]
**UPDATE: This has now been mass-produced, repackaged, and officially made available as a GRS product:
[ Ссылка ]
***UPDATE: The gate changer will also work with the Legends Pinball joystick control panel.
***UPDATE: The GRS Button Hole spinner Version 2 will work but is a bit too sensitive with Legends products. If you can find Version 1(TS-BSP01) that is recommended. Only Version 2 (TS-BSP02) is sold direct from thunderstickstudio.com. I have also tested the GRS push-pull spinner Version 1 (TD-DOT-01) and Version 2 (TS-DOT-02). Version 2 is too sensitive for Legends products. Also, the push-pull functionality will NOT work on Legends products. It can be used as a spinner only.
PARTS USED (updated to reflect official GRS products):
ThunderStick TOS GRS Switchable 4-to-8-Way Restrictor All in One Kit: [ Ссылка ]
ThunderStick TOS GRS Switchable 4-to-8-Way Restrictor Extension kit: [ Ссылка ]
Arcade Joystick - 4-to-8-way switchable restrictor - Configuration Tool Video: [ Ссылка ]
Arcade Joystick - 4-to-8-way switchable restrictor - Firmware update Video: [ Ссылка ]
Software & Firmware Download: [ Ссылка ]
GRS USB Button Hole Spinner: [ Ссылка ]
ADDITIONAL PARTS USED FOR GAMER PRO MOD:
I used the Gamer Pro supplied USB cable to connect from the back of the Gamer Pro control deck to the Sabrent USB hub inside the control deck.
(2) Sabrent 4 Port USB 2.0 Hubs: [ Ссылка ]
15 ft. USB 3.0 extension cable: [ Ссылка ]
OVERVIEW OF GAMER PRO MOD:
Use the supplied gamer Pro USB cable and connect it to the USB port on the back of the Gamer Pro and feed the cable inside the control deck to the USB hub. The GRS gate changer's Arduino board and GRS spinner will plug into the hub inside the control deck. Then the hub's USB cable feeds out the back of the control deck through the same hole that the other USB cable feeds into. I then connected the female-to-male USB extension cable to the hub's USB cable coming out of the back of the control deck. The extension cable connects to a powered or passive hub on the other end. That hub is plugged into the Core.
Ещё видео!