Links to all the parts (not including the OEM SV650 parts that directly transferred over) I used for the GSXR front end swap:
-2006/2007 GSXR 600 fork (purchased used locally)
-2006/2007 GSXR 600 triple minus the upper clamp (purchased used locally)
-2005/2006 GSXR 1000 upper clamp (purchased used locally)
-Aztec8 speedometer mount (www.aztec8.com)
-4x 1.75" T-bolt clamps (www.siliconeintakes.com)
-SVRP 3.5" riser clip-ons (www.svracingparts.com)
-SVRP brake reservoir mount (www.svracingparts.com)
-GSXR radial master cylinder (purchased used locally)
-CRG RC2 shorty lever for the GSXR radial master cylinder (purchased off ebay)
-Galfer SS brake lines with double banjo pre-bent 90 degrees at the master cylinder and
measured to fit the GSXR front end with the 3.5" riser clip-ons (www.svracingparts.com)
-GSXR radial calipers (purchased used locally)
-2006/2007 GSXR front wheel (purchased used locally)
-2006/2007 GSXR front fender (purchased used locally)
-8x 1/4" rare earth magnets (www.leevalley.com)
-8x 1/4" rare earth magnet holders (www.leevalley.com)
-8x nuts and bolts to hold the magnets + magnet holders in place (www.leevalley.com)
-1" x 3" sheet aluminum bent to hold the hall effect sensor 2-3mm away from the face of the rotating magnets (Home Depot)
-Hall effect sensor (Search Cherry hall effect sensor on Ebay)
--------------
SVRiders thread on the magnets + hall effect setup:
[ Ссылка ]=
Tool for removing the castle nuts that holds the triple tree in place to the frame:
[ Ссылка ]
Please visit SVRiders.com for anything else you need to know. It is there, trust me.
Thanks for watching!
Subscribe!
Ещё видео!