In this video I am going to show you how to make a USB load tester, which is very useful device to check current and voltage consumption of your USB powered devices.
*Circuit Diagram was included in the video. (Follow that Diagram)
You need:
1) Panel Voltmeter/Ammeter - [ Ссылка ]
2) USB Type A Female connector x1 - [ Ссылка ]
3) USB Type A Male connector x1 - [ Ссылка ]
4) 10W 5 Ohms Resistor x2 - [ Ссылка ]
5) 220 Ohms resistor x4 - [ Ссылка ]
6) 5mm LED 3V x2 - [ Ссылка ]
7) 2Pole 2Position 6Pin Switch x2 - [ Ссылка ]
8) Dual side Perf board (2cmx 8cm) x1 - [ Ссылка ]
9) Some Quality wires
Thank you.
Subscribe for more future creative project videos.
Subscribe LahisTech: [ Ссылка ]
_____________________________Music_______________________________
Song: Fredji ft. Arcade - Ocean (Vlog No Copyright Music)
Music promoted by Vlog No Copyright Music.
Video Link: [ Ссылка ]
Coconuts by MBB [ Ссылка ]
Creative Commons — Attribution-ShareAlike 3.0 Unported — CC BY-SA 3.0
[ Ссылка ]...
Music promoted by Audio Library [ Ссылка ]
DIY USB Load Tester
Теги
USB load tester5V load testerusb loadtesterdeviceelectronic loadusbloadperf board100v voltmeterammeterpanel voltmeter ammeterhomemade load testerusb tester10w resistordummy loadlahistech load testerbest 5v voltage testerportable usb load tester10w 5ohmyb27vacreative channeleasy homemade usb load testerusb load tester wiring diagrampower bankchargerDIY load testerhow to make load testervoltage measuringdiy usb load tester