Adjusting the zero stop in your Huskemaw scope is quick and easy but it helps to understand a few things first.
#1 Be sure the turret is on the correct revolution and at your 200 (or 100) yard zero.
2. Thread the zero stop down to the bottom of the turret post and notice the gap increase between the bottom of the turret and the zero stop ring.
3. Thread the zero stop back up toward the turret until it engages or hits the turret.
4. Then rotate the zero stop back about a quarter turn being sure to align the white mark on the zero stop with the corresponding white mark on the scope tube.
5. Hand tighten using a small flat head driver.
A flathead driver was included with your scope purchase but you may also use the flathead tool from an eye glass repair kit or similar tool set.
Got questions? Call Paul at Best of the West Arizona at: 480-682-7763.
