In this video I go over the Drill Doctor 500X and show how to sharpen drill bits. I cover how to measure your bits to see if they are 118 or 135 degrees prior to sharpening as well as how to sharpen masonry bits.
I give a final review on the drill doctor and at the risk of giving it away, I love this tool and an mot ashamed to admit that everyone should probably have one if they go through bits like I do!
There are various models available from Drill Doctor. In this video I show the DD500X. This model is virtually identical to the DD350X as well as the DD350X. The difference between the models being the drill bit angles that can be sharpened. The 350x will only do 118 degrees (and can reshaope a 135 to 118 as can the upper two models). The 500X can do both 118 and 135, the 750X can do a range from 114 to 140 degrees. IT can also sharpen bits up to 3.4 inch. The 350X and 500X both have ranges from 3/32" to 1/2"
Incidentally, I actually reshape a 135 degree bit to 118 in this video. I also cover how to measure the angle of the twist drill bit you want to sharpen.
Affiliate Links to Drill Doctor Products:
Drill Doctor X2 [ Ссылка ]
Drill Doctor DD350X [ Ссылка ]
Drill Doctor DD500X [ Ссылка ]
Drill Doctor DD750X [ Ссылка ]
Drill Doctor Replacement Wheel [ Ссылка ]
Drill Doctor Carry Case [ Ссылка ]
00:00 Introduction
00:23 Overview of Drill Doctor
02:30 The Drill Doctor Manual
03:09 Measuring Drill Bit Angle
03:30 How to Sharpen a Drill Bit
05:55 Making a Split Point
08:40 Final and My Opinion
#sharpening
#Drilldoctor
#howto
