How to Index a new Vortex Strike Eagle rifle scope + battery fitting.
This video demonstrates how to index your elevation and windage turrets on your new rifle scope after you have zeroed at the range. It also shows you how to replace the battery for the illuminated reticule.
FIREARM SAFETY
Always ensure your firearm is safe before use:
1. Safety Catch applied.
2. Magazine removed / Integral magazine emptied.
3. Chamber, bolt face and action (magazine well) clear of rounds and empty cases.
4. Working parts/bolt fully open and locked.
Indexing the Elevation Turret
After your riflescope is sighted in, the zero stop ring should be installed. Once in place, the zero stop ring will only allow the turret to dial down 1.25 MOA past the sight-in zero to accommodate shots that are closer than the sight-in zero.
1. Loosen and remove the Elevation Turret cap using the included turret tool. Gently pull the turret dial straight up and off the turret post, being careful not to rotate the post.
2. Place the zero stop ring over turret post.3. Push the ring down until seated, then rotate the ring clockwise until it stops.
4. Reinstall the turret dial, lining up the “0” mark with indexing line on the scope body.
5. Replace and tighten the Elevation Turret cap.
NOTE: Although installing the zero stop ring is highly recommended, it is not required to operate the scope. The Elevation Turret can still be indexed to zero after sight-in even if the zero stop ring is not installed.
Indexing The Windage Turret
Strike Eagle® riflescopes feature a Windage Turret that allows you to reindex the zero indicator after sight-in without disturbing your zero setting. Though not a required process, reindexing the Windage Turret allows you to quickly return to your original zero setting if temporary windage corrections are dialled in the field. To reset the Windage Turret:
1. After completing the final sight-in, remove the Windage Turret cap and pull the turret dial straight off the turret post.
2. Reposition the turret dial with the “0” mark on the cap aligned with the zero-reference line on the scope housing and push the dial straight down. Avoid rotating while pushing down.
3. Be sure the turret dial is fully seated and replace the Windage Turret cap
Replacing the Battery:
1. Unscrew the outer cap cover.
2. Remove the battery.
3. Replace with a new CR2032 battery, text on the battery facing outwards.
4. Reinstall outer cap and tighten firmly.
FOLLOW ME FOR EXTRA CONTENT
YOUTUBE – [ Ссылка ]
INSTAGRAM - [ Ссылка ]
FACEBOOK - [ Ссылка ]
#vortexoptics #strikeeagle #indexing #zeroing #jackalfirearms #joncresswelluk
Ещё видео!