Converting the rear brake of my 1994 Trek 930 Singletrack from rim to disc brake.
The disc brake mount converts old bike frames to accept disc brake calipers.
Take out or loosen the bolts, remove the wheel.
Attach the mount to the frame (rear stays). Align the hole with the dropout and then tighten the bolts, the mount should sit flush on the frame. Once you have all the bolts tightened, check and make sure it’s sturdy before putting back the wheel.
The mount looks sturdy.
Put back the wheel with the disc rotor installed, insert the QR skewer into the hole and tighten it to secure the wheel in place.
Install the IS to Post adapter (160mm) and then the disc brake caliper.
Remove the old rim brake and replace the cable with a longer one.
Are disc brakes better than rim brakes? Leave me a comment below.
**********************************************
Trek 930 Singletrack series:
Disc Brake Converter 2.0 Review + 180mm Rotor Upgrade! [ Ссылка ]
Disc Brake Converter 2.0: Trek 930 Goes Full Disc Brakes! [ Ссылка ]
Worth Upgrading to Hollowtech II? [ Ссылка ]
Narrow Wide Chainring: 1x8 Setup [ Ссылка ]
Uphill Resistance: Ztto 8-Speed 11-46T Cassette [ Ссылка ]
Dirt Off My Trek 930, What Next? [ Ссылка ]
Pushing Trek 930 Up This Steep Hill [ Ссылка ]
Reviving A Vintage Trek 930 To MTB [ Ссылка ]
**********************************************
Tracks:
Free Range by Mona Wonderlick [ Ссылка ]
Creative Commons — Attribution 3.0 Unported — CC BY 3.0
Free Download / Stream: [ Ссылка ]
Music promoted by Audio Library [ Ссылка ]
Flexy — Land of Fire [Audio Library Release]
Music provided by Audio Library Plus
Watch: [ Ссылка ]
Free Download / Stream: [ Ссылка ]
#trek930 #rimtodisc #discbrakemount
Danyo Sports Channel Episode 109
Youtube: [ Ссылка ]
Reddit: [ Ссылка ]
Facebook: [ Ссылка ]
Instagram: [ Ссылка ]
Twitter: [ Ссылка ]
![](https://i.ytimg.com/vi/vBfyoB_95ow/maxresdefault.jpg)