I've been asked to make this video for some time and I was just waiting for a vehicle to come in that needed new studs. Well, not only did I get one in that needed a new stud, but it needed 2 studs. This doubles our fun for this video. The principal was the same for both studs. Some of you might not agree with this method and that's OK. But I can say that I've done it this way for many years and have not had one come back yet for an issue. However, if you feel you don't want to employ this method, you can remove the axle nut, slide hammer the hub out of the bearing, replace the stud on the bench, press the hub back into the bearing, and hope your bearing doesn't go bad as a result of separating it. Either way works. Here's some links to some tools you might find useful that were mentioned in the video.

Cutting Wheel: [ Ссылка ]

Air Hammer: [ Ссылка ]

Thread File: [ Ссылка ]

Discussion about this video: [ Ссылка ]

The best place for answers to your automotive questions: [ Ссылка ]

Facebook: [ Ссылка ]

Twitter: [ Ссылка ]

Google+: [ Ссылка ]

Information on Premium Membership: [ Ссылка ]

Stay Dirty

ETCG

Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information.  EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video.  Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result.  Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.

свернуть