Pay attention, if you are switch to solid mount, use the same bolt for sping leveling nut set up, the four hex bolts are too short for solid mounts!
Hi, It's me. I got my pre-order Sovol SV07 this week. After play it for a while. I realize that the bed leveling process is a bit of tricky and lack of detail instruction on manual. So I made this video and hope that will help.
So my unit auto bed leveling feature does not work as good as it on SV06 PLUS. It takes a while to figure it out, and I got a condition that will works for me. I think Sovol will update the firware and manual on the later patch. But, here is what I got for you guys.
No guarantee to have a perfect first layer on first try after following the instruction. But it should give you a sight head to the right direction of set up the printer if you are beginner.
If you have comment and thought, please leavel it on the comment section below. If you like the video, please consider subscribe and like the video.
My affiliate link to purchase Sovol SV07, no extra cost on you:
[ Ссылка ]
SV07 Review:
[ Ссылка ]
SV07 Beginner set up tutorial:
[ Ссылка ]
SV07 Input shaping guide:
[ Ссылка ]
SV07 Extruder common issue repair guide:
[ Ссылка ]
Intro: 0:00
Prepare work: 0:53
Spring spacers with leveling nuts mount: 1:25
Step1 : adjust 4 leveling nuts 1:33
Step2 : pre-heat 1:51
Step3 : z tilt 2:14
Step4 : z calibrate 2:32
Step5 : bed leveling 3:16 (adjust four corners)
Step6 : bed mesh 4:32
Step7 : first layer test print 4:57
Solid spacers mount: 5:17
Spacers measurement: 5:32
Pre-heat nozzle and bed: 6:02
Z tilt: 6:07
Z calibrate: 6:12
Bed mesh 6:42
Issue: 6:56
___________________________________________________________________________________________________
#sovol #sv07 #3dprinting #3dprinter #3dprint #3dprinted #creality #sovol #biqu #bigtreetech #anycubic #xyzprinting #flashforge #prusa #ender #ender3 #ender3pro #ender3v2 #ender3s1 #diy #diytool #3d打印 #impresion3d #3дпечать #drucken #druck
