Visit the Rotorbuilds page for the Flying Squirrel to decide what components to choose: [ Ссылка ]
To purchase a BNF fully assembled Flying Squirrel fill out this form: [ Ссылка ]
Tesa Tape: [ Ссылка ]
3M VHB 5952 Tape: [ Ссылка ]
Solder: [ Ссылка ]
Flux: [ Ссылка ]
Introduction 0:00 - 0:37
Tools Required 0:37 - 3:11
Before Starting 3:11 - 3:38
Flight Stack Screws 3:38 - 5:26
Vertical Plates 5:26 - 13:13
Arm T-Brackets 13:13 - 16:07
3D Print Prep 16:07 - 21:50
Top Cage Installation 21:50 - 24:31
Arms Installation 23:31 - 27:19
ESC Power Lead 27:19 - 40:31
12V Regulator and Fan 40:31 - 53:11
Testing, FC, Receiver, 53:11 - 56:15
Motor Mounting and Immortal T 56:15 - 1:03:53
FPV VTx install 1:03:53 - 1:11:57
Battery Quick Release 1:11:57 - 1:16:53
Go and Test Fly 1:16:53 - 1:17:52
Remove Top Cage 1:17:52 - 1:19:35
Power Port Soldering 1:19:35 - 1:23:44
Bluetooth Install 1:23:44 - 1:25:53
PCB Extension 1:25:53 - 1:29:17
Top Buttons 1:29:17 - 1:35:47
Power Port Install 1:35:47 - 1:36:52
PCB Motherboard Mounting 1:36:52 - 1:47:02
Sensor Ribbon Cable 1:47:02 - 1:51:56
Top Plate Install 1:51:56 - 1:56:28
Side Plate Install 1:56:28 - 1:57:48
Lens Mount Assembly 1:57:48 - 2:09:22
Lens Mount Install 2:09:22 - 2:13:15
Power Testing 2:13:15 - 2:14:42
LCD Case Build 2:14:42 - 2:24:02
Shimming Procedure 2:24:02 - 2:32:20
Outro 2:32:20 - 2:32:35
![](https://s2.save4k.ru/pic/wf13UWNd5B4/mqdefault.jpg)