This video is about checking the geyser element/rod if its working or not plus a little info on the current in the water.
To do this test you need to open the safety cover first then remove the thermostat and reach the terminals of the geyser element .After that set the multi-meter to the continuity and touch the terminals of the geyser element with the two probes of the multi-meter , if there is any reading that means the geyser element is working . but you need to perform another test by touching one probe to the terminal and another to the surface or metal body and if there is still a reading then the geyser element is bad , if no reading only then its in good shape.
I have show to additional faulty geyser elements in case you get results on your geyser elements like them so do see the video till the end.If you found that the geyser element is good and you still have the problem in water heating or current in the water the problem must be something else.
TOOLS USED
- Screwdriver ( BUY LINK - [ Ссылка ] )
- Multi-meter , buy link - [ Ссылка ] (affiliate)
MY GADGET AND YOUTUBE EQUIPMENT'S
- MOBILE - GLAXY GRAND 2
- TRIPOD ( BUY LINK - [ Ссылка ] )
- LOW BUDGET TRIPOD ( BUY LINK - [ Ссылка ] )
- MOBILE HOLDER ( BUY LINK - [ Ссылка ] )
- BEST MICROPHONE ( BUY LINK - [ Ссылка ] )
- ANOTHER GOOD MIC ( BUY LINK - [ Ссылка ] )
- LOW BUDGET MIC ( BUY LINK - [ Ссылка ] )
- TRIPOD WITH MOBILE HOLDER AND MIC COMBO ( BUY LINK - [ Ссылка ] )
HOPE THIS VIDEO IS HELPFUL FOR YOU
THANK YOU FOR WATCHING
MORE VIDEOS
How to drain geyser - [ Ссылка ]
How to change geyser heating element - [ Ссылка ]
Geyser thermostat repair - [ Ссылка ]
Self start relay check - [ Ссылка ]
Car service at home - [ Ссылка ]
