[ Ссылка ]
[ Ссылка ]
12V 5 LED OUTPUTS 5 x 1A , Each led will come on after previous and when all led come on -they will turn off and start from beginning.
This circuit can be used to indicate left and right turn on a car, motorcycle, motor-bike. Two identical circuits will be needed, one for left and one for right.
Each led will come on after previous and when all led come on - they will turn off and start from beginning.
Power: + , - Have protection against reverse supply voltage. (Black 12V+ and Red 12V- wires)
Direct 5 x 12V Outputs 1A - can carry powerful diode up to 25w each ( 5 x 25w) (5 x black/red wire for each LED)
If you use led 1.8V diodes must be soldered 330 ohms resistor.
The module is for one side of the car, for two sides(left and right turn signal) need to be used 2 modules.
Power supply - 12-15V DC( car voltage)
With trimmer is adjusted the time when all diodes is on.
The module start with power on. For the led light can be used led strip, or separate diodes – for example 5 x 3 led.
Can be used water resistant 5x LED 25w for each side of the car
