Timestamps for various topics:
Beginning: 0:00
Designing the basic gear: 1:15
Exporting STL + cloud translation rant: 9:42
Slicing considerations: 11:15
Designing a more compact gear: 12:58
Inserting the embedded nuts: 17:44
Creep+runout problem discussion: 18:45
For my measurements on creep: [ Ссылка ]
Improved gear design: 19:52
Screw-through-hole-technique: 23:41
Modelling through-screw gear: 25:06
Drilling a centered hole through shaft: 29:27
Cutting screws while not messing up the threads: 33:04
Full gears playlist: [ Ссылка ]
Next part on parameters: [ Ссылка ]
Compound gears and chamfering: [ Ссылка ]
My apologies for the fireworks bangs, I didn’t want to wait for a quiet period to reshoot that footage. I don't think it’s so bad that the footage is ruined.
You can find Fusion360 files for some of the gears shown, and the shaft drilling jig here:
[ Ссылка ]
I have made extensive use of these two references, which you can also consult if you don’t have the time to wait for my upcoming uploads:
[ Ссылка ]
[ Ссылка ]
If you have any questions, comments or suggestions please leave those down below.
