www.solidremote.com - Solidremote SR-B2 is fully compatible with BENINCA TWV and CUPIDO garage door remotes, suitable for many BENINCA roll up remotes, sliding door remotes, slide gate remotes and swing gate remotes as well as other BENINCA radio entrance automations using Beninca TWV and CUPIDO systems.
If you have bought new remotes, you have 2 ways to program it, via receiver or remotely.
If you would like to program to receiver, such as typical BENINCA RR.2WBV Receiver, the programming procedure is as follows.
1. Press and release the button P on the receiver.
2. The Red LED will light up for 3 secs, then go out for 1 sec and then light up again for 5 secs.
3. While the red LED is on, press the button on the transmitter to associate with channel 1.
4. Other transmitters can be then be recorded by pressing a button within 5 secs from recording the previous transmitter.
5. To end wait 5 secs, the receiver will exit programming.
6. Press the transmitter button to test operation.
If you would like to program new Beninca remote using remote storage method (without open control panel or receiver), please refer to following *** you do need at least one original Beninca To.Go transmitter that is already coded into the opener.
1. Press the hidden button on the memorised original transmitter.
2. Within 5 seconds, press the button on the memorised transmitter corresponding to the channel to associate with the new transmitter.
3. Within 5 seconds, press the button on the new transmitter to associate with the channel selected above.
4. The receiver will memorise the new transmitter and promptly exit programming.
Note: Be careful not to accidentally store unwanted transmitters during remote learning procedure.
