Watch the design, printing, and setup instructions: [ Ссылка ]
Laser Cutting Settings:
1/8 inch (~3 mm) thick plywood
Epilog Zing 30W Laser Cutter
Focus = Somewhere in between right on the surface, and halfway through the material thickness.
Speed = 50% = 822 mm/min
Power = 100%
Frequency = 5000 Hz (500 to 5000 Hz will work. Lower frequency can leave a less burned edge, but takes more power to cut through)
Material Sources:
1/8 inch (~3 mm) thick plywood 12 x 24 inches
- Amazon 6 pack: [ Ссылка ]
- Amazon 12 pack: [ Ссылка ]
- Amazon 20 pack: [ Ссылка ]
- Craft supply stores also sell 1/8in thick birch plywood. Check places like Michaels and Hobby Lobby.
- If you need a lot of plywood, I purchase in bulk from Ocooch Hardwoods. They carry many different thicknesses and types of plywood and hardwoods. Tell them Daniel @ Engineerable sent you. [ Ссылка ]
1/4 inch (~6mm) thick plywood 12 x 24 inches
- Amazon 3 pack: [ Ссылка ]
- Amazon 6 pack: [ Ссылка ]
- Amazon 12 pack: [ Ссылка ]
- Craft supply stores also sell 1/4in thick birch plywood. Check places like Michaels and Hobby Lobby.
- If you need a lot of plywood, I purchase in bulk from Ocooch Hardwoods. They carry many different thicknesses and types of plywood and hardwoods. Tell them Daniel @ Engineerable sent you. [ Ссылка ]
The products shown here were purchased by me with the intent to use. I did not receive any free items, and I am not being paid or compensated for this review. The video and description may contain affiliate links. If you click on a link, I may receive a commission. Money earned helps to support my channel and bring you more informative videos about engineering, crafting, and DIY.
Ещё видео!