This video is about the Machine Origin, Job Origin and Start Location when using Co2 Laser Software. The Laser software I use is Lightburn. Now I know that not everyone uses Lightburn Software so towards the end of the video I will briefly explain where to find these settings in two other Laser Software Packages - RD Works (for Ruida Controllers) and AutoLaser (for the TopWisdom Controllers).
Laser Cutting Resources - [ Ссылка ]

== If you'd like to support my channel financially so I can continue to produce content you can do via PayPal here --- [ Ссылка ] --- Thank You ====

0:27 - You may need to refer to your user manual for the position of your machine origin. On this machine when it powers on the laser head will move to the MACHINE ORIGIN (Top / Rear Right) and then return to the last position or user set origin.
0:53 - Machine Origin - The RED SQUARE
3:40 - Start From Locations
4:47 - (Start From:) Absolute Coordinate
5:56 - (Start From:) Current Position
8:00 - (Start From:) User Origin
10:10 - Job Origin (The GREEN SQUARE)
14:43 - Using the Centre Job Origin Effectively on Circles
And Irregular Shapes like (16:27) Chopping Boards
18:07 - Where to find these Settings discussed in RD WORKS - Ruida Controllers
21:30 - Where to find these Settings discussed in RD WORKS - TopWisdom Controllers
21:51 - Thanks for Visiting.

Until next time, take care
Cheers Matthew
Visit Matt's Workshop at MW Laser [ Ссылка ]
Instagram [ Ссылка ]
Facebook [ Ссылка ]

== If you'd like to support my channel financially so I can continue to produce content you can do via PayPal here --- [ Ссылка ] --- Thank You ====

Any questions please feel free to email me matt@mwlaser.com.au or leave a comment below.

свернуть