In order to wire the solar charge controller to the battery I need to make custom wires. I'm using an old set of truck jumper wires that are #1 or #2 AWG. The Victron MPPT 250/100 charge controller has 35mm screw terminals. In order to use the flexible cable I need to crimp on a "ferrule" to the wire ends. This is a thin copper tube that slips over the small strands of copper to prevent deforming.

I'm also connecting the charge controller to my DC load center. I'm using a 125 amp DC circuit breaker from Midnite Solar.

To crimp the ends I"m using a hydroponic crimping tool from Amazon.

Detailed video about the Victron 250/100 MPPT Solar Charge Controller: [ Ссылка ]

Hydraulic Crimping Tool: [ Ссылка ]

Ferrule Ends: [ Ссылка ]

Ring Terminals: [ Ссылка ]

125 Amp DC Breaker: [ Ссылка ]

Victron Charge Controller: [ Ссылка ]

“As an Amazon Associate I earn from qualifying purchases.”

свернуть