For more follow me on:
[ Ссылка ]
[ Ссылка ]
Consider this less permanent out door pullup bar first. By homemademodern
[ Ссылка ]
THE FLANGES:
The flangs and pipe are threaded.
1. Put the flange in a vice and forced the pipe on the non lip side. (backwards). Leave the flang on the bar. You can tack weld if desired.
2. Force the other flange on (backwards), then remove flange. this will help screwing it on later
OR
If you you can't screw the flang on backwards it will screw on the correct way (lip side in).
Sink a slightly wider hole to accommodate the lip (1/4 inch) in the wood. Then Sink a hole for the pipe all the way through the wood.
You may need to improvise or modify these plans, be creative.
Share what you have done diffrently in the comments.
Thanks
Steven
This is what happens if you dont drill a hole and mount it to the inside of the posts.
[ Ссылка ]
Thanks for the likes! dont forget to subscribe.
Pull up bar supplies
Two 4x6 x 10ft 37.14
One 1 x 72 Gas Pipe 22.48
Three 50 lb Quikrete 14.94
Two 1 inch floor Flanges 19.92
One can Paint 3.98
One 1 3/8 Steel Flat Bit 5.65
Eight 2 inch x 1/4 bolts & washers 3.12
Total: 107.23
I recommended a drill guide 29.96
Follow me on:
[ Ссылка ]
[ Ссылка ]
