[ Ссылка ]
[ Ссылка ]
[ Ссылка ]
This video features the SEIO W120 Wave Pump operating in the 'Swell Mode' function and the aquarium used for this display was 120 cm x 45 cm x 60 cm
The pre-programmed pumps have 9 pre-set functions, as listed below:
1. STANDARD: Water flow can be varied from 6000-13,000 LPH by using the flow control buttons.
2. RANDOM: Water flow will start at 6000 LPH and gradually increase to the maximum flow of 13,000 LPH. Approximate cycle time in 21 seconds: 5--5--5-3-3 and will continue to repeat cycle.
3. FAST RANDOM: Water flow will start at 6000 LPH and gradually increase to the maximum flow of 13,000 LPH. Approximate cycle time in 5 seconds: Flow increases every second and will continue to repeat cycle.
4. GROUND SWELL: The pump will create an underwater varied current. Use the flow control buttons to adjust the wave shape.
5. SWELL: The pump will create a surging swell at the water's surface. Use the flow control buttons to adjust the wave shape.
6. SURGE: The pump will create an alternating surge from one side of the aquarium to the opposite side of the aquarium. Use the flow control buttons to adjust the wave shape.
7. TIDAL: Water flow will increase in 5/12 minute increments in the period on one hour and will continue to repeat cycle.
8. NIGHT: Water flow will decrease to 54% of standard flow rate.
9. FEEDING: Water flow will decrease to 6000 LPH then after 20 minutes will go back to the original setting
Please contact your local store for availability
For further information please visit [ Ссылка ]
Please note that we cannot answer questions via this site- please call one of our stores for any queries you may have regarding this video or any other aquatic topic. Thank you
