In this video I will show you how to connect multiple 'Light Emitting Diodes" in series without the use of any resistor on a breadboard.
If your LEDs dont light up here are a couple troubleshooting problems that you may have :-
1) 1 or more of the LEDs are facing the wrong way.
2) They light up but are very dim - Not enough voltage or you could have the LED the wrong way.
Some more interesting videos on Electronics :- 👇
✔How to make a "Laser Sensor" on a Breadboard :- [ Ссылка ]
✔How to make a "Light Sensor" on Breadboard :- [ Ссылка ]
✔How to make a "Dark Sensor" on Breadboard :- [ Ссылка ]
✔How to make a "Water Level Indicator" on Breadboard :- [ Ссылка ]
✔How to make an "Infrared Circuit" on Breadboard :- [ Ссылка ]
✔How to Adjust the Brightness of a L.E.D :- [ Ссылка ]
✔How to Adjust the Volume of a Buzzer :- [ Ссылка ]
✔How to Adjust the Speed of a Fan(DC Motor) :- [ Ссылка ]
✔How to make a "Reed Switch Circuit" on Breadboard :- [ Ссылка ]
✔How to make an "Electronic Dice" on Breadboard :- [ Ссылка ]
✔How to make a "Touch Sensor" using 555 Timer IC on Breadboard :- [ Ссылка ]
✔How to make a "Remote Tester Circuit" on Breadboard :- [ Ссылка ]
✔Touch 'on'/Touch 'off' L.E.D on Breadboard :- [ Ссылка ]
✔How to make a Simple Dark Sensor? :- [ Ссылка ]
✔How to make an "Electronic Wire Loop Game" on a Breadboard :- [ Ссылка ]
✔How to make an "IR Remote Tester" using IR Receiver Diode - TSOP1738 [Easy] :- [ Ссылка ]
Have a great day! Also make sure you SUBSCRIBE/LIKE/SHARE/COMMENT. 😊✌
Ещё видео!