▶︎ ➡️ LEARN HOW TO SKATE: [ Ссылка ]
► what? DIY SKATE WHEELS?? yes, these are HOMEMADE SKATE WHEELS
90a urethane used for these wheels: [ Ссылка ]
Spray used for Mold release: [ Ссылка ]
Modified Pressure chamber, so that there is an open and close valve for the inlet and outlet on the top. Connect to a compressor and keep pressurized 70-80 psi for total cure time: [ Ссылка ]
Convection oven that gives consistent heat and goes low enough for urethane cure-150 degrees F for 4 hours: [ Ссылка ]
¼-20 .75” flat head screw used on the base of the mold to join the bearing plug to the base: [ Ссылка ]
► Buy the MASTERBLADE frames here:
[ Ссылка ]
WATCH - KAREEM SHEHAB // THE MIND BEHIND MASTERBLADE FRAMES :
[ Ссылка ]
Follow Kareem Shehab & MasterBlade:
[ Ссылка ]
[ Ссылка ]
Join this channel and get access to exclusive content here:
[ Ссылка ]
100K, LETS GO ►🇬🇧[ Ссылка ] ►🇵🇹[ Ссылка ]
WHEELADDICT T-SHIRTS AND SKATES BUY HERE:
► [ Ссылка ]
Support this channel by using code "lino" at :
- [ Ссылка ]
- [ Ссылка ]
Support The Lino Life:
- [ Ссылка ]
Gear used to make my videos:
- [ Ссылка ]
my Tik Tok: [ Ссылка ]
my website: [ Ссылка ]
my Instagram: [ Ссылка ]
my twitter: [ Ссылка ]
my facebook: [ Ссылка ] .
#wheeladdict #ricardolino #becauseitsfun #skating #inlineskating
HOMEMADE SKATE WHEELS
Теги
ricardolinowheeladdictthelinolifeinlineskatesskatinginline skatingrollerskatevlogrollerbladingbladingbladergangroller skatemicro skatemicro inline skatestiktokdiy skate wheelshow to make skating wheels at homehow to make rollerblading wheelshow to make inline skating wheelshomemade skate wheels3 d printed core skate wheels3 d printfuture of skating wheelskareem shehabmasterblade framesmasterbike